operation
1 - list of parts
1. Left seat back frame
2. Right seat back frame
3. Base frame connector with flip clips
4. Left base frame
5. Right base frame
2 - frame assembly
Place the left and right base frames opposite each other, with the base frame connector between
them on a flat surface. Lift the flip clip on the left hand end of the base frame connector (a) and fit
the end of the left hand base connector into the tube (b). Close the flip clip over the tube (c) and
push down until the flip clip locks in place (d).
Repeat this procedure with the right base frame (5).
Take one side of the seat back frame. Hold the spring loaded pin down with your finger (e) then
push the end of the frame to the mount on base frame (f) until the pin locates into the hole (g).
Repeat this procedure with the other seat back frame.
Fit both ends of the seat back frames together by holding down the spring loaded pin (h) and
push the frames together (i) until the pin locates into the hole (j).
3 - fitting the footrest frame
Noting the orientation of the footrest frame (the vibration & music unit slot should be level with
the surface the unit is resting on.), hold the spring loaded pins on each side of footrest frame
down with your finger (a). Push the ends of the footrest frame into the back rest supports on the
base frame (b) until the pins locate in the holes (c).
4 - fitting the seat cover
Note: It is recommend that the back rest should be put in the most upright position prior to fitting
the seat cover. Please refer to step 7 on how to adjust the back rest.
Open the pocket at the rear of the seat cover back and slide over the seat backrest (a).
Stretch the bottom of the seat cover over the footrest frame (b).
Attach the clips under the seat (c).
5 - fitting and using the vibration & music unit
Note: See the care & maintenance section on the next page for information on battery fitting and
safety.
Noting the orientation of the music box, slide the top of the vibration & music box through the
hole in the seat cover and onto the footrest frame as shown (a).
Reverse the procedure above to remove the vibration & music box.
Press button (b) for music mode.
Press button (c) for vibration mode.
Both the vibration & music features are available in 3 levels and can be operated individually. Press
the button multiple times to select desired vibration/ volume levels or to turn each feature off.
6 - fitting the toy bar
Note: Toys may varies from illustration
Clip the toy bar to each side of the bouncer frame as shown.
Pull the clips off to remove the toy bar.
The toys are held onto the bar by Velcro
®
tabs.
WARNING: Never use the toy bar to carry the bouncer.
6. Footrest frame
7. Seat cover
8. Toy bar (Toys may vary from illustration)
9. Vibration & music box (requires 2 “C” type
batteries - not included)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern